mbawhe.blogg.se

Ecm sensor
Ecm sensor













The result: The became a gas guzzler, consuming about 30 litres of petrol (about 7 gallons) in 30 km (about 18 miles). I remember playing with the TPS in my friend's car and adjusting his TPS to about 2.5 volts at idle. The normal reading for a Honda is close to 0.6V at idle.

ecm sensor

Honda has an adjustable TPS sensor and if the initial if your RPM is high and cannot be controlled through the IACV, then the voltage readings of the TPS should be checked.

  • The TPS is located on the throttle body.
  • The ECM can also verify this information with the MAP or MAF sensor readings, thus increasing the injector pulse width and spark (ignition) timing. The TPS tells the ECM that the driver is pressing the accelerator pedal.
  • : Each 0.1 strength adds ~1.The throttle position sensor (TPS) is linked from the accelerator pedal to the throttle body.
  • Strength decreases further from the jammer
  • : Currently uses 100-10000 power, that translates to 0.1-1 jamming strength in a ~300-1000m radius.
  • : Remote guidance error added by signal jammer down to 75%.
  • : Signal jammer maximum error added to remote guidance reduced from 15m to 10m.
  • : Remote guidance missile direct accuracy reduction from jammers removed(they are affected by worse detection.
  • : Sensor scramblers stack, their effective strength is summed to determine the accuracy reduction.
  • : Sensor scrambler uses power and reduces bearing/range accuracy of enemy sensors.
  • : Signal jammer replaced with Sensor scrambler ECM",.
  • ecm sensor

    The variable power consumption is an quick and easy way to increase power demand when stress testing engines on an engine raft. Adding a second sensor scrambler at 2km range, you need 1,800 power on the second scrambler to increase the total strength to 1000, and the accuracy to 57%.Ĭontrary to its description, it uses only engine-power, but does not use the AI's processing. to get 100 strength or 76% accuracy at 500m you need 125 power (due to falloff with range). Reason: " Examples no longer up-to-date, still using 1-0.9 for sensor accuracy" The Discussion page may contain suggestions. This article may need updating to the game's current version.















    Ecm sensor